Building materials

Wheel, clip and cover spacers that hold reinforcement at the cover shown on the drawing, with PVC chamfer strips and profiles for forming clean arrises and edges in cast concrete.

Fiber reinforced cementitious cover blocks for maintaining concrete cover to reinforcement in slabs, walls, columns and beams.

Formwork panels and boards built for repeat pours, with hard-wearing faces that strike cleanly and hold dimensional accuracy across cycles.

The consumables that tension, seal and strike a formwork system — tie rods, wing nuts, cones, anchor plates and the fixings that go with them.

Compressible fillers that let adjacent pours move independently, and protection boards that shield waterproofing membranes before backfill.

Alkali-resistant mesh for reinforcing render and plaster, plus self-adhesive tape for crack-resistant board joints.

PVC waterstops cast into construction and expansion joints to seal basements, tanks and other water-retaining structures against ingress.

Marine-grade plywood for formwork and joinery, with sawn white wood for studs, bracing and general site carpentry.

Plasterboard for partitions and ceilings, and fiber cement sheet where moisture, fire or impact performance is specified.

Expanded metal lath with angle, stop and movement beads — the trims that reinforce plaster and give straight, protected corners and terminations.

Galvanised lintels for carrying loads over openings, with brackets and support angles for masonry and cladding.

Bed-joint reinforcement, ties and starter systems that tie blockwork together and control shrinkage cracking.

Cable tray and its fittings for running containment routes through plant rooms, risers and ceiling voids.

Trunking and fittings for distributing power and data containment through finished and service areas.

Clamps, hangers, threaded rod and channel supports for suspending mechanical and plumbing services.

Galvanised steel conduit with flexible conduit and couplers for electrical containment.

Edge trims that finish and protect tile terminations, with joint covers for floor and wall movement joints.

Scaffold components and access ladders for temporary works.

Anchors, bolts, screws and washers for fixing into concrete, masonry and steel.

General site hardware and consumables that keep work moving between deliveries.

Additional lines we stock or source to order. If it is not listed here, ask — sourcing is part of what we do.